Register
Log In
Home
Add Reply
Add Topic
June 2, 2015
Offline
Hi, can someone explain to me the set up for Auto Tour, and maybe what it is, does it have anything to do with presets? Auto Pan, Auto Scan, and Pattern work just fine, and when in the “PTZ Set” window I can’t do anything with the Auto Tour to add anything…
Think of the tour as like a bus route. You have set stops where the bus stops and then moves to the next stop. The tour consists of different presets, and you tell the camera to go to preset 1 for x amount of time, then it will move to the next stop and the next and so on so forth.
June 2, 2015
Offline
Heath,
So I’ve set up presets. The Auto Tour has what it refers to as “Scopes: 0-7” I assume just groups…so I could have 8 different Tours…correct? But how do you create the tour with say 10 different presets… can you also change the time it sits on a preset.
For example:
Scope 1:
Preset 001 – 10sec
Preset 002 – 5secs
Preset 003 – 7secs
etc…
Every camera is a bit different, you should be doing this through the OSD, correct? I would like to log into a PC on the same network as this DVR so I can log in and take a look. Can we set up a time when I can do so? also, can you provide me with the model# of this camera?
Thanks.
1 Guest(s)
