Register
Log In
Home
Add Reply
Add Topic
May 3, 2014
Offline
Need to connect outputs of two TP Loco M5 access points (Main) to an NVR.
Any advice as to how its done ? Can I connect the wires from the LAN port of the Access Point to a single router then to the NVR or
do I need two routers?
May 3, 2014
Offline
Actually I am proposing to use two pairs of M5 access points to transmit IP camera signals from two separate locations. Would this be ok or could I get away with using two (2) M5's from the cameras and one (1) as the Main connected to the DVR ?
January 3, 2014
Offline
The Nano that will act as an Access Point is not connected directly to the NVR it connects to the Network where the NVR is attached to. The second Nano is set to Station and bridged. Here is an article the i wrote not to long ago.
Jose Malave - IT Director| Toll Free: 866-573-8878 | E-mail: support@securitycameraking.com
1 Guest(s)
